Polypropylene Ball Valve
on Jul 15, 2015Specifications :
CONSTRUCTION – Three Piece Design.
END CONNECTIONS – Flanged End as per DIN Std.
BS 10 (Table D/E/F)
ANSI B 16.5 (ASA 150 #)
Manufacturing Standards – As per Manufacturer’s Standards.
Available M.O.C – PP ( Polypropylene).
HDPE ( High Density Polyethylene).
Available Size – ½” to 12”.
Dimensions :
Size (MM) Size (INCHES) OD D1 L T H 15 1/2" 100 13.5 129 13 69 20 3/4" 101 19 142 14.5 75 25 1" 121 25 164 20 92 32 1 1/4" 129 32 181 21 101 40 1 1/2" 140 38 184 21 110 50 2" 164 50 207 23 123 65 2 1/2" 182 63.5 230 24 140.5 80 3" 200 75 262 28 161 100 4" 228 100 300 30 180 150 6" 305 150 428 34 236 200 8" 367 201 489 31 280 250 10" 428 242 570 35 325 315 12" 486 293 585 34 309
List of Materials :
No. Description Material Quantity 1 Body PP/HDPE 1 2 Side Piece PP/HDPE 2 3 Ball PP/HDPE 1 4 Spindle M.S./S.S 1 5 Seat Ring PTFE 2 6 Seak Connector Neoprene Rubber 2 7 Spindle Seal Ring PTFE 1 8 Spindle O-Ring PTFE 1 9 Stud, Nut & Washer MM.S./S.S 361 REQ 10 Nut Cap PP REQ 11 Handle M.S. PP Coated 1 12 Handle Pin M.S. / S.S. 316 1 13 Handle Cap PP 1 Hydraulic Test Pressure.
BODY - 150 PSI.
SEAT - 100 PSI.
WORKING TEMP UP TO 80º C
NOTE:
- All Dimension are in ± 2 mm
- Maximum Working Pressure 10kg/cm2
- Hydraulic Test Pressure
- Table D/E/F/ASA 150 # DIN etc.